Lacquer 1ltr and Hardener UHS 25 Normal 0.5ltr
This is the highest quality transparent two-component acrylic clear coat with high content of solids. It provides a hard, high-gloss, scratch-resistant surface and excellent appearance. Since it is sufficient to spray 1,5 – 2 layers, spread evenly and dries quickly
Mixing ratio: 2:1 by volume
Hardener: 2K- HS Acrylic hardener SOLL UHS 25 “Normal”;
Dilution: Without thinner
Spraying viscosity 20 – 22 seconds at 20 °C.
Spraying pressure: 2 – 2,5 bar
Spraying nozzle:1,3 – 1,4 mm
Evaporation time: between layers approx 10min before baking 10-15min
Drying time: a) 8-10 h at 20°C; b) 25-30 min at 60°C
Layers: 1.5-2 layers
Pot life: 1 hour and 30 minutes at 20 °C
Sanding: Usually polishing is unnecessary, as the clearcoat SOLL UHS gives the surface a perfect look immediately after having been used. However, if some dirt inclusions appear, one recommends removing them wet, using abrasive paper with gradation of 1500÷2000 and then polishing the surface with abrasive compound.