Monofil Vario+ X Build Lt Grey 500 ml

Chromate-free 1K repair filler with outstanding filling properties. Applicable on sanded old 2K paintworks, shop primer and directly on steel, aluminium, galvanised substrates and several plastics (e.g. hard PVC, PPO/PA, ABS, ABS/PC, PC/PBT).

PRODUCT BENEFITS

1K filler to insulate sand through areas very high filling capacity
Fast drying
Good vertical stability
Outstanding sandability
Recoatable with all common solvent and water-based basecoats as well as with 1K and 2K topcoats

Application method Spray to test. Spray distance aprox. 10 – 15 cm apply 2 coats. Dry film thickness approx. 60 μm.

Flash-off time 5 – 10 min. in between coats

Drying time

Dust dry: after approx. 6 min.
Set to touch: after approx. 40 min.
Sandable: after approx. 1 h.

Not suitable to be recoated with 2K UP putties/body fillers. Not suitable for plastic substrate made of PE, PP, PP-Blends (e.g. PP/EPDM), polystyrene (e.g. Styropor®), thermoplastic coatings.

VOC Regulation :

EU limit value for the product (cat. B/e): 840 g/l (2007) This product contains less than 840 g/l of VOC.

Processing instructions:

Remove loose rust if necessary, sand substrates slightly with sanding paper P 180 – P 240, clean and degrease. After use hold the can upside-down and spray until the valve is empty in order to avoid the paint drying up in the valve. Processing conditions are from +10°C up to 80% relative air humidity.