Monofil Vario+ Rapid Build White 500 ml

Chromate-free 1K repair filler applicable on slightly sanded 2K old paintworks, shop primers and directly on steel, aluminium, galvanised substrates and several plastics (e.g. hard PVC, Hart-PVC, PPO/PA, ABS, ABS/PC, PC/PBT).

PRODUCT BENEFITS

1K filler to insulate sand through areas high filling capacity
Fast drying
Good vertical stability
Excellent sandability
Recoatable with all common solvent and water-based basecoats as well as with 1K and 2K topcoats

Application method Spray to test, spray distance approx. 10 – 15 cm apply 2 coats. Dry firm thickness 60 μm.

Flash-off time 5 – 10 min. in between coats

Drying time

dust dry: after approx. 6 min.
set to touch: after approx. 40 min.
sandable: after approx. 1 h.

Not suitable for plastic substrates made of PE, PP, PP-Blends (e.g. PP/EPDM), polystyrene (e.g. Styropor®), thermoplastic coatings.

VOC Regulation :

EU limit value for this product (category B/e): 840 g/l This product contains max. 840 g/l of VOC.

Processing instructions:

Before use, remove loose rust if necessary, sand substrates slightly with sanding paper P 180 – P 240; clean and degreaseshake aerosol until the metal balls inside the can rattle, then shake vigorously for another 2 minutes. Spray test. After use hold the can upside-down and spray until the valve is empty in order to avoid the paint drying up in the valve. Processing conditions are from +10°C up to 80% relative air humidity.