SOLL LIGHT BLUE BODY FILLER 3L SUPER LIGHT

SOLL LIGHT BLUE is the light-weighted putty, middle dense and very well workable. This upper putty is intended for filling small and bigger disparities. It is intended for common surface. It has good adhesion on aluminium and zinc materials. Thanks to low density it is very well sandable with several fold lower abrasive consumption. It has high resistance of stress on material. There is a minimal increase of weight of construction, so it is suitable for aircraft industry and ship-building sector.

Body Filler 3L and hardener

APPLICATION

Bonded surface must be without rust and old coatings. It is necessary to degrease the surface carefully, eventually to roughen with sanding paper:

glass fibre – sanding paper P40
steel, wood, cast-iron – sanding paper P60
existing coatings – sanding to bare metal with sanding paper P60

Hardening: The putty comes with hardener (DBPO – initiator, red paste in tube) the weight ratio:

For 100 parts of putty : 3 parts of hardener – recommended ratio for temperature 23C

Pot life: The putty is necessary to be used within 5 minutes after mixing with hardener at temperature 23C and hardening ratio 100:3. Pot life can be extended at temperatures lower than 23C (minimum 17C) and shortened at higher temperatures. Modification of hardening ratio can partly eliminate temperature influence on pot life.

Hardener ratio:

minimum 100 : 1  to extend pot life
maximum 100 : 4 to shorten pot life

Sanding: The putty is can be sanded after 20 – 30 minutes at temperature 23C and hardening ratio 100:3. Dry sanding starts with sanding paper P80 and finishes with sanding paper P120 – P180. Wet sanding starts with sanding paper P120 and finishes with sanding paper P180 – P240.

Top coats: can be used all common paint systems. The putty withstand baking temperature of 80C – 110C. If it is necessary to use the putty on anticorrosive primer and bake the enamel after that, then we recommend to use the baking primer, or more precisely two-compound epoxy primer. We do not recommend using of air- drying synthetic coatings and baking after that.